FLYMPH FORUM

Inspired thinking!

William Anderson wrote:Jeff, this is one of the coolest innovations I've seen for such a simple tool. Beautiful job. I need a way to cut uniform lengths of small wire while you're in research and development mode. Great post.

w

William, you have the woodworking skills and tools (not to mention the tidy workshop ) to create something along the same lines yourself. Why not make up just the "gauge" stick at the side of my block as a separate tool- specifically for the wire length you require? It doesn't take much math to calculate the length the finished item needs to be and you could make on to compliment or contrast your existing Maple blocks..... assuming you need to cut wire to specific lengths for wire cored spun bodies?

Thanks to all for the positive comments, just an hours messings in the workshop when I possibly should have been doing something more productive.

Mataura mayfly wrote:
Ah, the fluro orange thread...... it is not even Uni as the spool indicates, I just wound it off a bulk spool onto an empty Uni spool to fit bobbin holders. Its use was only for contrasting ability and thickness so it stood out well in the photos for demonstration purposes .

I didn't mean the thread but the plastic spools Pearsall's (Langley) are using nowadays. Sounds like you have nice friends.Since you sparked my interest I read this:http://en.wikipedia.org/wiki/Dacrycarpus_dacrydioides
Every day you learn something new...

dd

Mataura mayfly wrote:

William Anderson wrote:Jeff, this is one of the coolest innovations I've seen for such a simple tool. Beautiful job. I need a way to cut uniform lengths of small wire while you're in research and development mode. Great post.

w

William, you have the woodworking skills and tools (not to mention the tidy workshop ) to create something along the same lines yourself. Why not make up just the "gauge" stick at the side of my block as a separate tool- specifically for the wire length you require? It doesn't take much math to calculate the length the finished item needs to be and you could make on to compliment or contrast your existing Maple blocks..... assuming you need to cut wire to specific lengths for wire cored spun bodies?

Thanks to all for the positive comments, just an hours messings in the workshop when I possibly should have been doing something more productive.

Yes, but cutting the dozen wraps of wire would require something more than scissors. More innovation is needed.

Something more than fly tying scissors- agreed...... but there are lots of workshop designed scissors out there that will handle cutting several layers of fly tying grade wire in one snip. I would suggest a dedicated set of wire cutting scissors specifically for this purpose or your going to trash a pair of Dr Slicks pretty damn quick!
Another option is a pair of fine bladed tin snips (sorry to any sheetmetal workers out there as cutting wire with tin snips is like swearing in church), again, reserved for this application only.

Or do I have to design and build some kind of cutter/anvil included wire gauge for you? ...... give me a day or two.......

Mataura mayfly, Howdy;

Jeff perhaps a simple backing of plate steel and the judicious use of a hammer and
sharp chisel for cutting the bulky wire bundle...

hank